Emmeline Garage Doors October 24th, 2017 - 01:02:40
If you are going to heat or cool your garage or will include a workshop in your garage then you should consider one of Missions energy efficient doors. Foam is sandwiched between two steel plates on each panel providing an R-Value of 14.5. These panels are designed with shiplap joints to keep the outside weather outside. A heated or cooled garage will add value to your home by providing additional year around comfort. Metal garage doors are also provide a relatively low maintenance option. Strong galvanized panels will resist wind loads and sagging. Losing your garage door during any type of storm places the entire home at risk for losing its roof. A strong door is important in providing protection to your family and your homes contents.
There will be times when your door may fail to operate. It happens from time-to-time no matter how well it is installed and maintained, so there is no need to panic. More often that not, the battery in your garage remote is dead or it is some other simple garage door repair. It is also a good idea to keep additional power back ups with you such as a manual device (generator, UPS, etc) or additional batteries. Or, you can manually open the garage door until you figure out what the is causing the problem.
The Vintage Plus line of Delden Garage Doors is a very popular and affordable carriage door. The 25 gauge steel pre-painted doors are 2 inches thick insulated with polystyrene with a vinyl backing. They are reported to have an R-value of at least 6. Obviously these doors are not meant to be used in areas that have tough winters or where you are going to heat or cool your garage. One of the problems with using polystyrene insulated panels is that this type insulation leaves gaps which reduce the effectiveness of the insulation.
In the past, the biggest concern with operating an overhead garage door was the potential risks associated with the springs used for balancing the door weight. Pre mid 1960s garage door installations typically relied upon a pair of stretched (tensioned) springs to assist the operation of the garage door pivoting hinges. These springs became loaded (tensioned) as the door was moved into the closed position. Unloading (releasing) of the stored spring energy occurred as the door was opened to the horizontal overhead position. One of the most dangerous aspects of these spring systems was that after a period of time, often without any maintenance or inspection, the points of attachment of these springs would rust or become weak.